Saturday 16 August 2008

Waiting for the glue to dry

While waiting for the glue to dry on the letters for my latest layout, I thought I would write up what I did to make it again, as it prooved so popular last time.




This layout was done as part of the Summer Stash Bash being run on UKS throuhout August. This one uses a Becky Fleck Page map and is part of the Tuesday Technique challenge - to use stamps somewhere.

Supplies

Fancy pants Floral Chic My sweetie paper
Autumn Leaves florish stamps
MM alphabet stamps
glitter
Some chipboard or back of notepad
Green and white acyrlic paint
Cosmic shimmer powder (blue, green, red, yellow)
Transparency
Doodlepack digi kit by Iona Havenaar
Sheet of transparency
G;ossy accents glue

The sketch called for four photos but I didnt have four in a 'set' so as last time, I had to mess around in photoshop before I could get started. Having picked these photos they seem to match the paper so well I just couldnt resist. And the paper was way too prrruudy to cover up, so instead of using the sketch as it stood I changed things a bit. In order to use ALL the pretty pattern I used my snap off craft knife and a glass cutting mat to cut out the flowers and swirls in the pattern just enough to slip the photos underneath.

I gutted the back of the top photo in order to use the back of the double sided cs as the journalling block.

For the stamping part of the challenge I used the swirl stamp on the naked chipboard, using stazon black ink after painting the chipboard with acrylic paint using a sponge brush. I dabbed white paint into the green to match the green paper. When dry I carefully cut the swirls out and glued on to make the journal frame.

Still using black stazon I stamped the title with the MM foam alpha (gosh its a while since I used those) and then using the same technique as before, smeared glue over them and then glittered with pee wee glitter.

Finally, the bubbles are printed out from a rather old digi kit by Iona Havenaar, called Doodlepack. I resizes some of the round tags which looked a bit like bubbles, printed them out onto a transparency, then used red, yellow, blue and green cosmic shimmer powder to paint a rainbow effect. Once glued onto the LO I added a 'bubble' of rangers glossy accents to make them 3D.

No comments: